01
Fully Automatic Warm Isostatic Press WIP
Overview
Warm isostatic press is used to seal multiple layers of film in vacuum packaging bags, which are then placed inside a chamber. A servo hydraulic mechanism is used to move the chamber and the material into a hot water sealing cylinder environment. The high-pressure boosting pump increases the water pressure inside the chamber to a high level, and temperature and pressure are evenly applied to the components inside the pressure cylinder. This equipment is used for pressing multiple layers of ceramic capacitors and other films to enhance the physical and electrical properties of the products.
1.The working principle of the warm isostatic press involves using components such as a high-pressure vessel, heating system, cooling system, pressure control system, and safety protection system. The pressure control system applies pressure while the heating system increases the temperature, causing the pressure inside the vessel to gradually rise until it reaches a state of high temperature and high pressure. In this state, the material undergoes a series of physical and chemical changes, thereby improving its properties.
2.Suitable for sealing green bodies ranging in size from 4" to 8".
3.Capable of holding multiple sealed green bodies simultaneously.
4.Maximum pressure range of 70-200 MPa with minimal pressure fluctuation: ±0.2 MPa.
5.Adjustable pressure holding time in three stages, ranging from 0 to 3000 seconds.
6.Maximum operating temperature up to 85°C.
7.Constructed entirely from 304 stainless steel for enhanced durability.
8.Special design allows for easy replacement of sealing rings.
Cutting-edge Features
1.Synchronized display of the pressure process setting curve and tracking curve.
2.Supports free editing, setting, and saving of multi-stage pressure, time, and process reference curves.
3.Automatically completes the entire process of preheating, pre-pressing, pressure increase, pressure holding, and pressure release after loading.
4.Equipped with a high-sensitivity light curtain at the material discharge inlet to ensure safe operation.
Option
1.Optional high-pressure types: integrated or helical
2.Cylinder diameter range: Φ180–Φ600
Technical Specifications
| capacity | Depends on the type of equipment and materials |
| Maximum cylinder diameter size | Maximum cylinder diameter 600*800mm depending on product model |
| cycle | 5-30min/ time depending on the product pressure holding time |
| Pressure range | 0-200Mpa depends on the product model |